Added a motion sensor, caused problems with other devices

Today I added an Ecolink Z-Wave Motion Sensor into my mix (that all went well), but now I note that my Tapt switch (Zigbee) has stopped talking to the hub.

I’ve removed the switch entirely and am attempting to re-add it, and the hub is not finding it.

Is there any issue with interoperability here? Suggestions on how best to proceed?

Never mind, read somewhere else on the forums that the tapt switch will stop trying after three unsuccessful connection attempts. I reset the breaker, and it showed up as an “Unknown Thing”.

A quick trip to the IDE and I was able to change it to GE Zigbee Switch and all is well.