3-way dimmer with "Power into Light" configuration

[professordave (DavidK)]

This sounds like my scenario. I have 3, 3 ways, each has line in one box and neutral in the other.

Placement of load switch is important. Needs to be in the “other” box, not the box that the line comes in on. Otherwise turning off the light, also turns off the “auxiliary” switch.

You can use this device handler to set up zwave association. Then once setup, set device handler back to “dimmer switch” so everything runs local.

Device Handler for GE Dimmer Switches with Settings for All Options

I have created a new device handler for GE Dimmer Switches. It is a copy of the standard SmartThings “Dimmer Switch” that is normally used for the GE Dimmers but adds the ability to change all of the “advanced” features (Indicator Light, Invert Switch, Z-Wave Dim Steps, Z-Wave Dim Delay, Manual Dim Steps, and Manual Dim Delay). In the past I have used the “Pablo Dimmer Switch” to set these but the perfectionist in me didn’t like the hacky nature of that solution. Other than the added settings this has no difference from the standard handler so for day to day use I suggest using the standard handler and only use this to update settings. https://github.com/nuttytree/Nutty-SmartThings/blob/master/devicetypes/nuttytree/ge-dimmer-switch.src/ge-dimmer-switch.groovy