Can you manually reset a device's state?

From a SmartApp, I mean… specifically, a SmartSense motion detector. Under some specific circumstances, I don’t want to have to wait a full minute (or whatever its threshold is) before receiving another active event.

Is there some way to set its status to inactive so the next time motion occurs the active event is sent?

This is very interesting. I’d like to know this as well!

Maybe @Tyler can lend some advice here?

If the question is whether or not you can have the SmartSense Motion sensor (v1) display “No Motion” sooner than the built in reset time the answer is no (to my knowledge).

@urman might be able to chime in and confirm.

The new one is much quicker (~12 seconds).

1 Like

Unfortunately, I can’t use the new one in this sitch as I need a powered one.

1 Like